Table of Contents
Advertisement
Removal and Replacement Procedures
Removal and Replacement Procedures
Cabinet Leveler or Caster
Refer to Figure 4-1 while performing these procedures.
Leveler or Caster Removal:
1. Turn Off the cabinet power switch.
2. Unplug the cabinet power cord from the wall outlet.
3. Carefully move the cabinet to an area with enough room to allow the cabinet to be laid
on its side.
4. Remove all computer components mounted in the cabinet.
5. Carefully lay the cabinet over on one of its sides.
6. Unscrew the desired leveler, or remove the desired caster by removing four mounting
nuts and pulling the caster off.
Leveler or Caster Replacement:
1. With the cabinet still on its side, screw in the leveler. Or, place the caster over the four
mounting studs, and attach the four mounting nuts. Tighten the nuts.
2. Carefully lift the cabinet back up to an upright position.
3. Install all computer components that were removed previously.
4. Carefully move the cabinet to its install site.
5. Plug the cabinet power cord into the wall outlet.
6. The cabinet is now ready for operation.
Lock and Latch
The lock and latch are located in the rear door.
Lock and Latch Removal:
1. Open the rear door.
2. Grasp the bracket supporting the lock and latch mechanism.
3. Remove the screw and star washer in the center of the bracket. The bracket will slide
off, and the lock and latch mechanism will slide out from the rear door.
4. Carefully note the position of the two screws attaching the latch catch to the cabinet
frame (the middle holes in segment 7 and 8 along the right rear cabinet frame). You will
need to mount the latch catch in the same position when replacing the mechanism.
5. Remove the two screws securing the latch catch to the cabinet frame.
Lock and Latch Replacement:
1. Align the two screw holes in the rear of the latch catch with the hole positions noted in
the removal process.
2. Attach the latch catch to the frame with two screws.
4-22
Chapter 4
Advertisement
Table of Contents
