Cosmetic Panel; Lower Cosmetic Frame; D Class Computer - HP A3765A Installation Manual

Cosmetic Panel

The cosmetic panel(s) are held in place with six plastic push pegs. These pegs can be
removed easily with a pair of long nose pliers. Compress the inside of the pin while
pushing it towards the outside of the frame.
Upper Cosmetic Frame Replacement:
1. Place cosmetic frame over top mounting space of the cabinet.
2. While holding the Cosmetic frame in place, insert the four mounting screws plus nylon
washers, then tighten screws

Lower Cosmetic Frame

The Upper and lower cosmetic frames are not inter-changeable. Each frame contains two
cosmetic panels. Refer to Figure 4-4 while performing these procedures.
Lower Cosmetic Frame Removal:
1. Remove the four mounting screws and nylon washers holding the lower cosmetic frame
to the cabinet. Be sure to keep the mounting screws and nylon washers together.
(3)
2. Be sure to hold the lower cosmetic frame
screw, as the frame will fall away from the cabinet with no mounting screws in place.
3. Refer to the Cosmetic Panel section for instructions concerning the cosmetic panels.
Lower Cosmetic Frame Replacement:
1. Place the lower cosmetic frame
2. While holding the frame in place, insert the four mounting screws plus nylon washers,
then tighten screws

D Class Computer

Before removing a computer from the cabinet, be sure that the computer data base has
been recently backed up. To remove a D Class computer from the cabinet, perform the
following steps.
WARNING The D Class computer can weight up to 49.5 kg (110 lbs.). It is
recommended that two CEs lift the computer off or onto the cabinet
mounting assemblies.
D Class Computer Removal:
1. Put the D Class power switch in the OFF position.
2. Remove the power cord from the back of the computer. Also remove all I/O and
interconnect cables from the back of the computer.
3. Refer to Figure 4-5. Remove the two screws
retainer bracket, located in the rear, upper corner (left or right). This allows the
computer to slide in and out of the cabinet.
Chapter 4
in place while removing the last mounting
(3)
over lower mounting space of the cabinet.
(3)
holding the computer frame to the
(1)
Removal and Replacement Procedures
Removal and Replacement Procedures
4-11