Computer Lock Out Assembly; Figure 4-7 Computer Tray Diagram - HP A3765A Installation Manual

Figure 4-7 Computer Tray Diagram

Computer Tray Replacement:
1. Align tray over the fully extended L bracket and slide assembly guide pins (3), and
lower into place.
2. From underneath the tray (2), insert the four mounting screws (1) and tighten.
3. Install D Class computer onto the tray and slide assembly (refer to D Class computer
replacement instructions).

Computer Lock out Assembly

There can be two computer lock out assemblies (one upper and one lower) in a 4 computer
cabinet. These assemblies are inter-connected by a safety rod to allow one computer to be
extended at a time. The computer lock out assembly is a manual device and should be
centered during normal cabinet operation.
Computer Lock Out Assembly Removal:
1. Refer to Figure 4-8. From the top lock out assembly, remove the center slide and
mounting screw
(1)
Chapter 4
and lift off the lock out slide.
Removal and Replacement Procedures
Removal and Replacement Procedures
4-15