Side Cover; Base Cover; Pdu - HP A3765A Installation Manual

Removal and Replacement Procedures
Removal and Replacement Procedures

Side Cover

Refer to Figure 4-1 while performing these procedures.
Side Cover Removal:
1. Remove the two mounting screws at the bottom of the cabinet.
2. On the right side cover, open the rear door and remove the two mounting screws on the
upper door hinge and lower door hinge (that secure the hinge to the side panel).
3. Grasp the sides of the side cover (pulling the bottom of the panel away from the cabinet
offers a better grip), then lift up and away.
Side Cover Replacement:
1. Grasp the side cover on the sides and align it with the cabinet at a vertical angle with
the bottom out and the top toward the top of the cabinet.
2. Lower the side onto the top edge of the cabinet side so the top of the side cover hooks
onto the top of the cabinet.
3. With the side cover flush with the cabinet frame and insert the two mounting screws in
the bottom. Tighten the screws.
4. On the right side cover, insert the mounting screws through the upper and lower door
hinge into the side panel and tighten screws.

Base Cover

Refer to Figure 4-1 while performing these procedures.
Base Cover Removal:
1. Remove the mounting screw located on the top edge, center, of the base cover.
2. Pull the base cover away from the bottom of the cabinet.
Base Cover Replacement:
1. Align the base cover hooks on the bottom of the cabinet frame and roll the base cover
until the mounting holes in the cabinet and base cover align.
2. Insert the mounting screw. Tighten the screw.

PDU

Refer to Figure 4-2 while performing these procedures.
PDU Removal:
1. Turn OFF the power switch on the front of the cabinet.
2. Unplug the cabinet power cord from the wall outlet.
3. Remove the top cap (refer to top cap removal).
4. Unplug the PDU harness from the back of the ON/OFF switch.
4-8 Chapter 4