Fastening The Machine And Drill Stand With An Anchor; Fitting The Hand Wheel - Hilti DD 30-W Manual

2. Lock the carriage on the drill stand at the maximum distance from the working surface.
Note
The carriage must be locked in the uppermost position. The machine with the water collector
holder can then be mounted on the drill stand without the water collector coming into contact with
the working surface.
3. Open the clamping piece by turning the locking bolt.
4. Fit the drilling machine onto the carriage.
5. Close the clamping piece by turning the locking bolt.
6. Make sure that the drilling machine is correctly fastened to the drill stand.

5.3.4 Fastening the machine and drill stand with an anchor

Note
Fastening the drill stand with an anchor requires use of the DD M12 S accessory set which, among
other items, includes the DD-LR-CLS anchor spindle and the DD-LR-CLN nut.
1. Mark the center of the hole to be drilled with a cross. The lines of the cross should be longer than the
diameter of the water collector.
Note
The water collector has four protruding marks that can be aligned with the cross.
2. Set the Hilti HKD-D M12x50 anchor for fastening the drill stand adapter plate at a distance of 12 cm
from the hole center mark.
Note
When setting the anchor, observe the instructions for use enclosed with the anchor.
3. Mount the machine on the drill stand. → page 16
4. Turn back the two leveling screws until they no longer project.
5. Place the drill stand, with the machine mounted on it, over the clamping spindle and then secure the drill
stand temporarily by screwing on the clamping nut (DD M12 S accessory set).
Note
Tighten the spindle securely only after the core bit has been positioned exactly over the center
point of the hole to be drilled ( → page 20).
6. Level the drill stand by turning the two leveling screws.

5.3.5 Fitting the hand wheel

Note
The hand wheel can be fitted on either side of the drill stand.
1. Fit the hand wheel onto the axle.
18 English
Printed: 06.07.2017 | Doc-Nr: PUB / 5283534 / 000 / 05