Sata Connectors - VIA Technologies EPIA-M920 User Manual

2.2.9. SATA Connectors

The two SATA connectors on board can support up to 3 Gb/s transfer speeds.
The SATA connectors are labeled as "SATA1" and "SATA2". The pinout of the
SATA connectors are shown below.
SATA1 SATA1
SATA1 SATA1
Pin Pin Signal Signal
Pin Pin Signal Signal
1 Ground
2 STXP_0
3 STXN_0
4 Ground
5 SRXN_0
6 SRXP_0
7 SATA1_+5V
SATA2 SATA2
SATA2 SATA2
Pin Pin Signal Signal
Pin Pin Signal Signal
1 Ground
2 STXP_1
3 STXN_1
4 Ground
5 SRXN_1
6 SRXP_1
7 SATA2_+5V
Table Table 19 19: SATA connect : SATA connector pinouts
Table Table 19 19 : SATA connect : SATA connect
Note: Note: Note: Note:
If users want to use the SATA Disk-on-Module flash drive on the board, please use the SATA2 connector.
or pinouts
or pinouts or pinouts
EPIA- - - - M920 EPIA M920 User Manual User Manual
EPIA EPIA M920 M920 User Manual User Manual
Figure 23 Figure 23: SATA connectors : SATA connectors
Figure Figure 23 23 : SATA connectors : SATA connectors
26