Connecting Channels 2 To 4 - Siemens SITRANS F FST030 Operating Instructions Manual

Connecting
5.4 Transmitter power supply, communications and I/Os connection
5. Connect wires to terminals using a screwdriver.
6. Termination of channel 1. The numbers refer to table Terminal layout (Page 42).
7. Tighten cable gland.
Table 5- 1
Active configuration
Note
Active or passive current output is preselected at ordering.
5.4.5

Connecting channels 2 to 4

Channel 2 is for output only and channels 3 to 4 can be connected as either inputs/outputs
or relays, see Preparing for the connections (Page 41)
Connect wires
1. Remove cap and ferrule from cable gland and slide onto cable.
Wall mount enclosure: Remove blind plug and fit cable gland.
2. Push cable through open gland and cable path.
3. Restore ferrule and tighten cap to lightly hold cable in place.
44
Active current output
④
+
⑤
-
Schematic of active/passive configuration
Passive current output
⑤
⑥
Passive configuration
SITRANS F Ultrasonic flowmeters FST030 (HART)
Operating Instructions, 08/2017, A5E35971532-AC
+
-