Table of Contents
Advertisement
In order for the pluggable equipment to be disconnected from the supply, the socket outlets shall be
installed near the equipment and shall be easily accessible.
▪
For each electronics rack, the electrical outlet is within 1 foot (30 cm) of the equipment.
▪
For each electronics rack, access to each power cord is easily accessible behind wooden panels.
To remove the wooden panels, lift up and towards you. The panels are located under each main
display (left, center, and right). No tools are required for the removal of the wooden panels.
To disconnect the room lighting from the AC mains supply, turn off the switch labeled (lighting
disconnect).
Note:
HIGH LEAKAGE CURRENT. EARTH CONNECTION ESSENTIAL BEFORE
CONNECTING SUPPLY.
Important Safeguards for RealPresence Immersive
Studio Flex
Regulatory notices describe safety and legal considerations for using the RealPresence Immersive Studio
Flex system.
Save These Instructions
Read and understand the following instructions before using the system:
▪
Always disconnect the system from power before cleaning or servicing.
▪
Do not spray liquids directly onto the system when cleaning. Always apply the liquid first to a static-
free cloth.
▪
Do not place any liquids on the system.
▪
Do not disassemble this system. To reduce the risk of shock and to maintain the warranty on the
system, a qualified technician must perform service or repair work.
▪
Avoid using this system during an electrical storm. There may be a remote risk of electric shock
from lightning.
System Rating for RealPresence Immersive Studio Flex
Input 1: 100-240 V, 3.0A, 50/60 Hz
Input 2: 100-240 V, 4.0A, 50/60 Hz
Note:
This equipment uses multiple disconnects. See the instructions below for quick
disconnect of the racks and lighting controller. Please disconnect all before servicing.
The main system consists of one electronics rack unit which is considered "pluggable equipment." The
room lighting system is considered to be "permanently connected equipment."
EMERGENCY DISCONNECT
▪
In the event of an emergency, power to the system may be disconnected by turning off the POWER
DISCONNECT switch installed in the room.
Polycom, Inc.
Regulatory Information
24
Advertisement
Table of Contents
