Storage And Callout; Operation Steps; Function Key For Sampling System - UNI-T UTD2025C Operating Manual

Operating Manual for UTD2000/3000

Storage and callout

As shown in following figure, STORAGE in MENU
control area is function key of storage system.
Figure 2 22 Function key (storage) for sampling system
STORAGE key can be used to display storage setup menu. You
can save oscillograph waveform or setup status to internal
storage area or U disk to call out saved waveform by RefA
(or RefB) or call out setup status by STORAGE key. Waveform
display area of oscillograph can be saved to DSO contents in U
disk in a form of bitmap. Saved bitmap can be read by PC computer.

Operation steps

Please press STORAGE Enter into type menus.
There are 3 types, namely, waveform, setup and
bitmap.
2. Please refer to Figure 2-16 for selection of type
waveform and entry into following waveform
storage menu. Please call out REF (reference
waveform shown in the second page) from Section
2 of the chapter after saving waveform.
Form 2-16 Waveform storage menu (the first page)
50