Waveform Delay - UNI-T UTD2025C Operating Manual

Operating Manual for UTD2000/3000
comparison without waveform overlapping for the
first and second channels.
2. To measure delay of sine signal caused by
circuit then observe waveform variation.
Delay of automatic measurement channel
To press MEASURE button to display automatic
measurement menu;
To press F1 key to enter into measurement menu
category for selection;
To press F4 key to enter into time measurement
parameter list;
To press F5 key twice to enter into 3/3 page;
To press F2 key to select delay measurement;
To press F1 key to select CH1 then press F2 key to
select CH2 then press F5 as enter key
You can see delay value from "CH1-CH2 delay" in
F1 area.
Observation of waveform variation (shown in
following figure)
Figure 3-2: Waveform delay
74