Storage System Settings - UNI-T UTD2000M Operating Manual

UTD2000M User Manual
size and shape of XY graphic can be adjusted via "SCALE" knob for both channels. Changing time base can acquire
a Lissajous pattern with good displaying effect.
With its unique X‐Y display mode, it can display waveform in a channel and X‐Y Lissajous pattern simultaneously.
In addition, this series of units also have following functions, for example,
Auto Measuring Function
Cursor Measuring Function
Reference or Mathematical Function
Following Functions are not Effective under X‐Y Mode
Window Expansion Function
Horizontal "POSITION" knob
Key Points
Display Format: "Vector Display" will fill in the blank area between proximal sampling points, while "Point
Display" only displays sampling points.
Waveform Capture Rate: waveform capture rate refers to the waveform refreshing times per second and it
impacts the unit's capability to display the dynamic change of signal rapidly.
2.7 Storage System Settings
As shown below, STORAGE key located in the control area is the function menu for storage system.
Press STORAGE key to display storage system settings where it allows you to save a waveform shown on the
oscilloscope or the unit's settings into the internal storage or U‐disk, and reload the saved waveform from "REF A"
or "REF B" submenu or reload the saved settings from certain submenu. After U Disk is inserted, waveform
displaying area can then be saved into the U‐disk in the format of bitmap.
Operation Steps:
Press STORAGE key to enter into "submenu", including reference waveform, settings and bitmap.
1、 Select "Reference Waveform" submenu to enter into "Reference Waveform Storage Menu" shown
below, See Table 2‐16; After the reference waveform is saved, reload the same using "REF" key (reference
waveform, page XX). See REF‐operation steps for details.
Table 2‐16 Reference Waveform Storage Menu
Menu
Type
Signal Source
Save
Fig. 2‐33 Storage System Menu Key
Setting
Reference waveform
CH1
CH2
1～10
Description
Select the waveform being displayed for signal source
Set that the waveform is from CH1
Set that the waveform is from CH2
Save the reference waveform into internal storage of the
unit. Select storage location using "MULTIPURPOSE" knob
48