Chapter 2: Instrument Setup - UNI-T UTD2025C Operating Manual

Chapter 2: Instrument Setup

By now, you have been familiar with operation of
vertical control area, horizontal control area and
trigger system menu for UTD2000/3000 series digital
storage oscillograph preliminarily. You should be
familiar with setup of digital storage oscillograph by
menu operation by introduction shown in previous
chapter. It is suggested to read Chapter 1 if you have
not been familiar with above operation and methods.
The chapter is mainly to introduce following themes
Set vertical systems of [CH1], ]CH2],] MATH],
]REF] , ]OFF] ]VERTICAL POSITION] and
]VERTICAL SCALE];
Set horizontal systems of ]MENU] or ]HOR
MENU], ]HORIZONTAL POSITION] or
[HORIZONTAL SCALE];
Set trigger systems of [TRIGGER LEVEL],
[MENU], ]50%] and] FORCE];
Set sampling mode of [ACQUIRE];
15
Operating Manual for UTD2000/3000
Set display mode of [DISPLAY];
Store and call-out for [STORAGE];
Set auxiliary system of [UTILITY];
Automatic measurement of [MEASURE];
Cursor measurement of [CURSOR];
Use execution buttons of [AUTO] and
[RUN/STOP];
It is suggested to read the chapter carefully to know
many measurement functions for UTD2000/3000
and system operation method.