Chapter Ix Storage And Load System; Setup Storage And Load - UNI-T UTD2000 Series User Manual

ΔT and ΔV can be measured, ΔT represents the time difference between two cursors,
ΔV represents the vertical space of two cursors. @T represents the time from current
cursor to horizontal cursor, @V represents the Y voltage value at cursor A, based on the
channel grounding point, the unit should be same as the current channel unit.
Press multifunctional knob key to select cursors. Change the cursor movement speed
based on the rotation speed.
(1) Tracking mode: Two cursors will move at the same time when adjusting cursors
through multifunctional knob.
(2) When cursor function is on, the measurement value will automatically display on
the top left of screen.
The DSO setting, waveform and screen image can be store in DSO or USB, the stored
setting or waveform can be recalled when needed. Press STORAGE to enter storage
setting interface.
9.1 Set storage and load
Press the Storage button, then Press F1 to choose storage type Setup, and you will
see the following menu.
Function Menu Setting
Type Setup
Storgte medium DSO, USB
Delete/File name
Save
Load
Figure 8-2 Cursor measurement for time
Chapter IX Storage
Figure 9-1 Function Key of STORAGE
Table 9-1 Storage setting menu
Description
Select storage type as setup.
Select storage location. DSO can store 20 groups, USB can sotre 200 groups.
Delete: Delete the stored files. File name: The menu will change to file name when
the storage medium is USB.
Store the file to current designated storage location.
Load the previous storage location in current designated storage location to get the
DSO back to stored setting status.
41
UTD2000 Series User Manual