Chapter Viii Cursor Measurement; Chapter Ix Storage And Load System - UNI-T UTD2052CL+ User Manual

Chapter VIII Cursor Measurement

Use CURSOR to measure waveform X axis (time) and Y axis (voltage). Press CURSOR
to enter cursor measurement menu.
8.1 Cursor measurement menu
Press CURSOR to enter cursor measurement menu.
Function menu Setting
Type OFF, time, voltage
Mode Independent mode, tracking
T unit Second, hertz
Source CH1, CH2, Math
8.2 Cursor measurement display
On CURSOR mode, user can move the cursor to measure, there are two types: voltage
and time.
Rotate the Multipurpose knob to adjust the position of AY, press Multipurpose knob to shift
cursor BY, adjust BY position with same way.
Set "tracking" with the mode, adajust Multipurpose knob, cursor AY and BY move in parallel.
A,B represent the voltage of coursor AY,BY
B-A represents the voltage difference between intersection of AY and waveform and
intersection of BY and waveform.
When time is measured, the figure below displays on the top left of screen:
Figure 8-1 Function Key of CURSOR
Table 8-1 cursor measurement menu
Description
Set measurement type
Select the moving mode of cursor. If independent mode is
selected, only cursor 1 and cursor 2 can be moved. If
tracking is selected, move cursor 1 and cursor 2 at the
same time.
Set the unit of time measurement
Set measurement source
41
UTD2000 Series User Manual