Configure Your Machine For A Wireless Network Using The One-Push Method Of Wi-Fi Protected Setup ™ (Wps) - Brother ADS-2200 Online User's Manual

Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless
Network > Configure Your Machine for a Wireless Network Using the One-Push Method of Wi-Fi Protected
™
Setup (WPS)
Configure Your Machine for a Wireless Network Using the One-Push
Method of Wi-Fi Protected Setup
Related Models: ADS-2700W
If your wireless access point/router supports Wi-Fi Protected Setup
machine's control panel menu to configure your wireless network settings.
Routers or access points that support WPS are marked with this symbol:
1. Press [Settings] > [Network] > [WLAN] > [WPS].
2. When [Enable WLAN? The Wired Network I/F will be disabled. Do you want to
continue?] appears, press [Yes].
The wireless setup wizard starts. To cancel, press [No].
3. When the touchscreen instructs you to start WPS, press the WPS button on your wireless access point/
router. Press [OK], and then your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your
device, go to your model's Downloads page on the Brother Solutions Center at support.brother.com.
To configure additional Network Settings, use the Web Based Management. See Related Information: Access
Web Based Management
Related Information
• Additional Methods of Configuring Your Brother Machine for a Wireless Network
• Access Web Based Management
™
(WPS)
™
(WPS), you can use WPS from your
92