Table of Contents
Advertisement
Home >
Network
>
Technical Information for Advanced Users
Wireless LAN Error Codes
Related Models: ADS-2700W
If the LCD displays an error code, locate the code in the table and use the recommended solution to correct the
error.
Error Code
Problem and Recommended Solutions
TS-02
The wireless access point/router cannot be detected.
1. Check the following:
2. If you manually entered the SSID and security information (SSID/authentication method/
TS-04
The Authentication/Encryption methods used by the selected wireless access point/router are
not supported by your machine.
Change the authentication and encryption methods of the wireless access point/router. Your
machine supports the following authentication methods:
•
•
•
•
If the problem is not solved, the Network Name (SSID) or network settings entered may be
incorrect. Confirm the wireless network settings.
TS-05
The security information (SSID/Network Key (Password)) is incorrect.
Confirm the Network Name (SSID) and the Network Key (Password).
If your router uses WEP encryption, enter the Network Key (Password) used as the first WEP
key. Your Brother machine supports the use of the first WEP key only.
TS-08
Two or more wireless access points that have WPS enabled are detected.
•
•
Related Information
•
Technical Information for Advanced Users
•
Make sure the wireless access point/router is powered on.
•
Move your machine to an obstruction-free area, or closer to the wireless access point/
router.
•
Temporarily place your machine within about 1 metre from the wireless access point/
router when you are configuring the wireless settings.
•
If your wireless access point/router is using MAC address filtering, confirm that the MAC
address of the Brother machine is allowed in the filter.
encryption method/Network Key (Password)), the information may be incorrect.
Confirm the SSID and security information, and re-enter the correct information as
necessary.
This device does not support a 5 GHz SSID/ESSID and you must select a 2.4 GHz SSID/
ESSID. Make sure the wireless access point/router is set to 2.4 GHz or 2.4 GHz/5 GHz
mixed mode.
WPA-Personal
TKIP or AES
WPA2-Personal
AES
Open
WEP or None (without encryption)
Shared key
WEP
Confirm that only one wireless access point/router within range has the WPS method active
and try again.
Try again after a few minutes to avoid interference from other access points.
> Wireless LAN Error Codes
114
Hide quick links:
Advertisement
Table of Contents
