Brother ADS-2200 Online User's Manual page 73

Only 300 × 300dpi can be selected when using long paper.
3. Scan Type
Select from a range of scan colour depths.
• Auto
Automatically detects whether the document uses colour and generates a scanned image of it. For
documents that mix colour and monochrome pages, colour pages will be scanned in Colour mode,
while monochrome pages will be scanned in Black & White mode.
• Black & White
Use for text or line art images.
• True Grey
Use for photographic images or graphics. This mode is more accurate because it uses up to 256
shades of grey.
• 24bit Colour
Use to create an image with the most accurate colour reproduction. This mode uses up to 16.8 million
colours to scan the image, but it requires the most memory and has the longest transfer time.
4. Document Size
Select the exact size of your document from a selection of preset scan sizes. If you select Custom, the
Custom Document Size dialog box appears and you can specify the document size.
5. Binding Method
Select Long-edge binding or Short-edge binding if you selected the 2 in 1 option in the Document Size
settings.
6. 2-sided Scanning
Scan both sides of the document.
Load only one document per scanning sequence when Carrier Sheet Mode or Plastic Card Mode is
selected.
7. Auto rotate rear image 180 degrees
Rotates the scanned image on the reverse side of the page 180 degrees.
8. Advanced Settings
Configure advanced settings by clicking the Advanced Settings button in the Scanner Setup dialog box.
• Paper
- Auto Deskew
Set the machine to correct document skewing automatically.
Because the Auto Deskew feature is automatically set to On if you select Auto for the Document Size and
set to Off if you select fixed for the Document Size, you cannot change the Auto Deskew setting.
- Auto Image Rotation
Changes the direction of the document based on the text orientation.
- Detect End of Page
Detects the end of page and automatically adjusts the size of a page when the length of the document
is shorter than the Document Size selected.
- Document Event Capture (Multifeed Detection)
When your machine detects a multifeed or a document size difference, you must confirm that the data
scanned so far has been saved, and then start scanning again from the next page or the beginning of
the document.
• Load documents of the same paper weight and size in the Paper Guides.
• Suitable paper weight: 50 g/㎡ to 209 g/㎡.
• Make sure the top of each page is not aligned. (Separation between documents of more than
0.33mm to 20.33mm needed.)
69