Brother ADS-2200 Online User's Manual page 148

Difficulties
Cannot scan.
Cannot scan to a
computer from the
machine.
Scanning does not start
even if I press the Scan
Button on the right side
of the machine.
(ADS-2700W)
Auto Start Scan
does not start.
(ADS-2700W)
Software Difficulties
Difficulties
Cannot save the settings
in Remote Setup or Web
Based Management.
Cannot start Remote
Setup.
Cause
Secure Function Lock is on.
The Pull Scan option in the Scan
from PC dialog box in Web Based
Management is disabled.
The WIA service is not started.
®
(Windows )
Brother PushScan is not set.
The settings for the first shortcut are
incorrect.
The settings for Auto Start Scan
(Shortcut 21) are incorrect.
Cause
The machine is processing.
The machine is being configured from
the machine's Control Panel.
The machine is turned off.
The machine is not connected to your
computer.
An error is occurring.
The machine is scanning.
The machine is being configured from
the machine's Control Panel.
Because you pressed the
on the machine before saving the
Remote Setup settings, the machine
went into Sleep Mode.
A USB flash drive is inserted into the
machine.
Suggestions
Contact your administrator to check your Secure
Function Lock settings.
See Related Information: Secure Function Lock
3.0.
Enable the Pull Scan option.
Start the WIA service. (Windows
Set Brother PushScan so that it starts.
Confirm the settings for the first shortcut.
Confirm the settings for Auto Start Scan
(Shortcut 21).
Suggestions
Wait until the machine finishes processing, and
then try again.
Stop configuring the machine from the Control
Panel and use Remote Setup or Web Based
Management instead.
Turn the machine on, and then try again.
Connect the machine to your computer, and then
try again.
Clear all errors, check the status is Ready on
Remote Setup and then try again.
Wait until scanning has finished and try again.
Stop configuring the machine from the Control
Panel.
Access Remote Setup again and save the settings.
button
Remove the USB flash drive.
®
)
144