Serial Interfacing Commands; Dport - Javad HPT404BT Operator's Manual

Command Line Interface

Serial Interfacing Commands

DPORT

3.3. Serial Interfacing Commands
3.3.1. DPORT
The DPORT is an object that responsible for data port interface configurations like Bit Rate, Flow
Control, etc.
DPORT [Parameter Name] [Parameters List] [/?]
Parameter Name
RATE
BITS
PARITY
FLOW
RS
DATATX
DATARX
The response of command without Parameter Name indicates all values:
RATE =0
BITS =8
PARITY =NONE
FLOW =NONE
DTR =0
RS =RS232
DATATX =UART
DATARX =UART, BT
30
Parameter List
0 – Maintenance Port baud rate, a default setting
1 – 1200 baud
2 – 2400 baud
3 – 4800 baud
4 – 9600 baud
5 – 14400 baud
6 – 19200 baud
7 – 38400 baud
8 – 57600 baud
9 – 115200 baud, a default setting
Set number of bits in one byte (8 or 7)
8 is a default setting
0 – None, a default setting
1 – Odd
2 – Even
0 – None, a default setting
1 – Not used
2 – HW (RTS/CTS)
0 - RS232, a default setting
1 - RS485
2 - RS422
use save, boot commands to activate modification
0 - UART, a default setting
1 - USB
2 - BT
0 - UART, a default setting
1 - USB
2 - BT
www.javad.com