Diagnostics And Identification Commands; Info; State - Javad HPT404BT Operator's Manual

3.5. Diagnostics and Identification Commands

3.5.1. INFO

The INFO command is used to retrieve the Radio ID along with its Hardware version, the loaded real-
time software version/revision and BootLoader's version/revision.
INFO [Parameter Name] [Parameters List] [/?]
Parameter Name
ID
SN
HW
SW
BL
BT
The INFO command without Parameter Name indicates all values:
HPT404BT UHF Transceiver, Javad GNSS
Product ID =46
S/N =0000000123BB
Hardware =Ver. 3.3
Software =Ver. 1.8 Rev 04 B24
BootLoader =Ver. 3.0 Rev 03
BT addr =00:18:D7:00:3C:C7

3.5.2. STATE

The STATE command is used to check the state of the wireless link, the unit in the link, and the alarm
control lines. To specify a radio unit (local or remote), the CONNECT command must be used in prior of
STATE command using.
www.javad.com
Product ID:
ID46 - HPT404BT
ID47 - HPT404BT_GSM
ID48 - AW400BT
ID49 - AW400BT_GSM
Six bytes Serial Number (SN)
1.0 - hardware version in numeric "Major.Minor" format
Ver. 1.0 Rev. A - displays software's version in numeric "Major.Minor" format and
revision in numeric format (range from 01 to 99) for engineering releases and alphabetic
format (A to Z) for manufacturing releases
Ver. 1.0 Rev. A - displays BootLoader's version in numeric "Major.Minor" format and
revision in numeric format (range from 01 to 99) for engineering releases and alphabetic
format (A to Z) for manufacturing releases
Bluetooth serial number
Diagnostics and Identification Commands
Parameter List
Command Line Interface
INFO
33