Page 1
Version 1.1 Last Revised October 13, 2010 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved.The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express written consent from JAVAD GNSS.
Please read these Terms and Conditions carefully. Terms and Conditions USE – JAVAD GNSS modems are designed to be used by a professional. The user is expected to have a good knowledge and understanding of the user and safety instructions before operating, inspecting or adjusting.
Page 6
Software and manual upon termination of your use of HPT135. All ownership, copyright and other intellectual property rights in and to the Software belong to JAVAD GNSS. If these license terms are not acceptable, return any unused software and manual.
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more www.javad.com...
This manual includes sample screen captures. Your actual screen can look slightly different from the sample screen due to the modem you have connected, operating system used and settings you have specified. This is normal and not a cause for concern. www.javad.com...
Technical Assistance WEEE Directive Technical Assistance If you have a problem and cannot find the information you need in the product documentation, contact your local dealer. Alternatively, request technical support using the JAVAD GNSS World Wide Web site at: www.javad.com. www.javad.com...
The VHF transceiver is also capable of receiving RF signals through a 50 Ohm impedance external antenna port. These signals are demodulated and output to the JAVAD GNSS receiver. HPT135 delivers a reliable radio link at up to 38.4 kbps over the air for the 25 kHz channel spacing, 19.2 kbps for 12.5 kHz, and 9.6 kbps for 6.25 kHz.
Through the data port the HPT135 can be connected to PC with Data-Ser Cable, DB9/DB15 (6ft/ 1.8m), or with JAVAD GNSS receiver with Data-Ser Cable, ODU-7/DB15 (6ft/1.8m). Through the power port the HPT135 can be powered. See “Powering HPT 135” on page 114 for...
Introduction Getting Acquainted External Antenna Connector 1.1.3. External Antenna Connector The external antenna connects to the BNC external antenna connector (Figure 1-3). Antenna Connector Figure 1-3. HPT135 back side 1.1.4. Mounting Bracket The mounting bracket (Figure 1-3) connects the modem to a standard pole/adapter (Figure 1-4). Mounting Bracket Figure 1-4.
Introduction Getting Acquainted Literature 1.1.6. Literature HPT135 literature, including manuals and other product information are available on the JAVAD GNSS website (http://www.javad.com): • HPT135 Operator’s Manual • Functional specifications 1.1.7. External Antenna (not included) Antenna type depends on the site requirements, and may be directional or omni-directional.
Outdoor Use and have an output rated for +12V, 10A. This may not be the same range as other JAVAD GNSS products with which you are familiar. : To avoid the introduction of hazards when operating and installing, before connecting of the...
Page 16
Do not operate the supply if it has received a sharp blow, been dropped, or otherwise damaged. Do not disassemble the supply. Warning: Before connecting the external power source and the modem, make sure that the power source matches the modem’s voltage and current requirements. www.javad.com...
• Programming the radio modem’s settings. • Loading the new modem firmware. See the ModemVU Software Manual available on the JAVAD GNSS website for details on configuring the VHF modem. To configure the HPT135 modem, have the following ready: • Computer running Windows®;...
Once you have established a connection between the modem and the computer, you will be able • Configure the modem and its components • Send commands to the modem • Use ModemVU to load new firmware to the modem www.javad.com...
4. Select the COM port the HPT135 modem is connected to (Figure 2-4). Click Connect. Figure 2-4. Connect to ModemVU 5. On the Radio Link tab, set the following parameters (Table 2-1) and click Apply (Figure 2- 5 on page 21). www.javad.com...
Page 20
1. In Auto mode rover receives the data from both base transmitter and repeater. The sophisticated algorithm of data receiving allows the modem to eliminate any data doubling. 2. In this mode the incoming data from base transmitter will be ignored. 3. In this mode the incoming data from repeater will be ignored. www.javad.com...
Use ModemVU to check the firmware version of your HPT135. 1. Connect your modem and computer. See “Connecting HPT135 and Computer” on page 18 for this procedure. 2. Start ModemVU. Select the HPT135 and than the COM port and click Ok (see “Configuring HPT135” on page 19). www.javad.com...
Page 22
Configuration Checking Firmware Version Power supply requirements 3. Click on Identification tab (Figure 2-6). Figure 2-6. Identification tab This tab lists important information about the hardware accessories and software properties. 4. Click FileDisconnect, then FileExit to quit ModemVU. www.javad.com...
2.7. Loading New Firmware The modem uses ModemVU to load firmware onto the modem. For more information, refer to the ModemVU Software Manual, available on the JAVAD GNSS website. 1. Download the new firmware package to your computer. 2. Connect your modem and computer, as described in “Connecting HPT135 and Computer”...
Page 24
6. Open the required firmware folder. Select the .xmd file and click OK (Figure 2-8): Figure 2-8. Load New Firmware 7. Wait until the new firmware version process will be complete. 8. Click FileDisconnect, then FileExit to quit ModemVU. www.javad.com...
(Antenna gain is not 163 dB (for 12.5 kHz Channel Spacing) included) 164 dB (for 6.25 kHz Channel Spacing) Roaming Speed for DBPSK modulation 75 mph / 120 km/h Modulation GMSK/4FSK/DBPSK/DQPSK/D8PSK/D16QAM Nominal Impedance 50 Ohms End to End delay 60 ms www.javad.com...
152 mm x 84 mm x72 mm Weight 900 g Power Supply Voltage +12VDC nominal Power Consumption (Average) 120W/38W/300mW – Continuous Transmit/ Transmit with 30% duty cycle/Sleep Housing/Color Aluminum / Two-tone JAVAD GNSS Green / Gray Antenna Connector BNC, 50W www.javad.com...
-8 dB for 25 kHz Channel Spacing -12 dB for 12.5 kHz Channel Spacing -16 dB for 6.25 kHz Channel Spacing Adjacent Channel Selectivity 70 dB for 25 kHz Channel Spacing 60 dB for 12.5 kHz Channel Spacing 50 dB for 6.25 kHz Channel Spacing www.javad.com...
Signal Name Details Power_INP 12 volts DC input Power_GND Ground, power return DB15 Connector This connector provides DB15 connectivity for the HPT135 with DTE. About using and configuration RS-485 please contact JAVAD GNSS Customer Support support@javad.com. Figure A-1. DB15 Connector www.javad.com...
Page 29
Transmit Data negative line (RS-422) / Transmit Data (RS-232) Ground Power Ground USB_D+ Positive line (USB) USB_D- Negative line (USB) Ground Power Ground External Antenna RF Connector The external antenna connector type is a BNC RF connector AEP Connectors p/n 6501-7051-003. www.javad.com...
The system’s range will greatly depend on the local conditions. Topography, local communications and even meteorological conditions play a major role in the possible range of RTK communications. If needed, use a scanner to find clear channels for communication. www.javad.com...
This product should never be used: • Without the user thoroughly understanding operator’s manual. • After disabling safety systems or altering the product. • With unauthorized accessories. • Contrary to applicable laws, rules, and regulations. HPT135 ANGER SHOULD NEVER BE USED IN DANGEROUS ENVIRONMENTS www.javad.com...
JAVAD GNSS’ Authorized Dealers During the warranty period, JAVAD GNSS will, at its option, repair or replace this product at no additional charge. Repair parts and replacement products will be furnished on an exchange basis and will be either reconditioned or new.
Need help?
Do you have a question about the HPT135 series and is the answer not in the manual?
Questions and answers