Charger Specifications - BW Technologies MicroDock II User Manual

Charger Specifications

Size: 8.6 x 8.2 x 7.8 cm (3.4 x 3.2 x 3.1 in.)
Weight: 97 g (3.4 oz)
Charger system ingress protection: IP20
Operating temperature: 10°C to 35°C (50°F to 95°F)
Humidity: 0% to 50%
Altitude: 2000 m (6561.66 ft.)
Power: 6 VDC , 2.5 A
Charging LED: Color-coded LED advises: charging, charge complete,
and charger fault
Charge time: Typically 2-6 hours
Pollution degree: 2
Installation category: I
This device complies with the FCC Part 15 and ICES-003 Canadian EMI
requirements. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules and ICES-
003 Canadian EMI requirements.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harm-
ful interference in which case the user will be required to correct the
interference at his/her own expense.
This product is designed for installation in an indoor location only.
All required National Electrical Codes and Safety Standards must
be followed.
For AC main installation, a circuit breaker should be included in
the building installation as a disconnect device for the equipment.
The disconnect device should be installed in close proximity to the
equipment and the device should be marked as a disconnecting
means for the equipment.
MicroDock II
Specifications
a Warning
89