Inserting/Replacing A Mmc/Sd Card; Accessing Test Results; Pc Requirements - BW Technologies MicroDock II User Manual

MicroDock II
User Manual

Inserting/Replacing a MMC/SD Card

The MMC/SD card is inserted in the base station inside the battery com-
partment. To insert or replace the MMC/SD card, refer to Figure 25. and
complete the following procedures:
Figure 25. Replacing a MMC/SD Card
1. Deactivate the base station.
2. Loosen the retaining screws from the battery cover. Do not
remove the screws from the battery cover.
3. Remove the battery cover and set it aside.
4. Remove the current MMC/SD card (if applicable).
5. Insert the new MMC/SD card into the memory card slot.
6. Replace the battery cover and tighten the retaining screws. Do
not overtighten the screws
To format an MMC/SD card, refer to
User Options Menu section.
76
Formatting the MMC/SD Card

Accessing Test Results

To access and view test results using Fleet Manager II, refer to the Fleet
Manager II Operator's Manual.
Data that is saved on the MMC/SD card can be transferred to a PC.
MicroDock II test results are saved in the .CSV format.

PC Requirements

The following version of the Microsoft Windows operating system sup-
ports Fleet Manager II:
• Windows XP
The computer must have the following minimum system requirements:
• 800 MHz processor
• 100 MB of free disk space
• 512 MB of RAM
The computer must also have the following software:
• A PDF reader
BW recommends that bump tests and calibrations be com-
pleted before accessing results on the PC.
in the
Note