MicroDock II
User Manual
3. The base station purges the N
4. The base station then applies the gas to the CO
5. The base station begins calibrating the remaining sensors. For
more information, refer to
(GasAlertMicroClip, GasAlertMax XT, and GasAlertQuattro
6. After calibration is complete, the base station displays the results
and performs a final purge to clear any remaining gas.
The countdown of seconds remaining displays beside Purge.
After calibration, the GasAlertMicro 5/PID/IR automatically
deactivates. To bypass the automatic shutdown, remove the
detector within 15 seconds after the final purge begins.
70
before applying the CO
2
sensor.
2
Automatic Datalog Download
Note
gas.
Calibration Results
2
After the calibration is complete, the base station LCD displays the
results.
H2S
Calibration Pass
only).
and Pass indicates that the calibration has passed. The detector is
now ready for use. Press
Calibration Fail
If calibration fails,
Example: H2S
Pass
Fail
No gas found (H
S is used as an exam-
2
ple, this applies to all gases)
Sensor is disabled
C
OK to return to normal operation.
displays beside the applicable gas.