Inserting The Gasalertmicro 5/Pid/Ir Battery Pack - BW Technologies MicroDock II User Manual

MicroDock II
User Manual
4. Hold the detector (serial number label down) at a 45° angle and
insert the bottom into the detector bay.
Ensure that the connector outlets on the bottom of the detector
lock into place over the connector pins in the docking bay, and
then lower the top into place.
5. Lower the lid and press down until the release tabs click.
When the detector has been inserted correctly, the RUN LED(s)
on the docking module lights yellow and the base station LCD
displays the
• the docking module number,
•
Unit Inserted,
• detector type, and
• detector serial number.
The GasAlertMicro 5/PID/IR detector LCD displays Microdock.
6. To bypass the base station identification screen, press any
button on the base station.
18

Inserting the GasAlertMicro 5/PID/IR Battery Pack

To insert the lithium battery pack, refer to Figure 9. and the following pro-
cedure.
C
Figure 9. Removing the Micro 5/PID/IR Lithium Battery Pack
1. Open the latch on the bottom of the detector.
2. Remove the battery pack by lifting the bottom of the pack upward
from the detector.
Do not disassemble lithium battery packs.
a Warning