Kronos 4000 series User Manual page 84

Chapter 4 Maintaining the Timeclock
Installing the Reader Spacers
You need to widen the badge reader slot if the badges your employees use are
more than .125 in (3.175 mm) thick. To widen the slot, you install two reader
spacers that come molded into the base of the timeclock.
Note
If you did not remove the spacers before you installed the Series 4000 timeclock,
you will need to remove them as explained in "Removing the Reader Spacers" on
page 4-32.
1. Open the timeclock's cover by using the security wrench to loosen the
security screw on the right side of the timeclock.
2. Use a Phillips screwdriver to loosen the two captive screws inside the
timeclock cover that hold the badge reader cover in place.
Number
1
4-36
Description
Screws that hold the badge reader cover in place
ADP, Inc.