Chapter 4 Maintaining the Timeclock
Adjusting the Width of the Badge Reader Slot
Removing the Reader Spacers
If you did not remove the spacers before you installed the Series 4000 timeclock,
you need to perform the following procedure to remove them from the back of the
timeclock:
1. Before you begin, collect data from the timeclock using your host application
software. For more information, see the "Using the Host Application
Software to Collect Data" section in this chapter.
2. Open the timeclock's cover by using the security wrench to loosen the
security screw on the right side of the timeclock.
3. Unplug the transformer from the AC power source. If you plugged the
timeclock into an external outlet, disassemble the strain relief clip at the
power cord's point of entry into the timeclock.
4. Unplug the power cord from the transformer.
4-32
ADP, Inc.