Controls And Functions - Accelerated Care Plus Neuroprobe 500 Pro User Manual

Electrotherapy / infrared therapy system

Hide thumbs

Table Of Contents

Table of Contents

A. POWER button. Press for power ON; press again for power OFF. The display initial default screen reads:

SELECT MODALITY / PROGRAM / TREATMENT OFF.

B. SELECT PARAMETERS button. Pressing this button enters the SET mode, and displays the following

parameters: battery voltage, screen contrast, button speed A-B, button speed beat etc, button delay, audio, and

select laser type. Most stimulation parameters may be adjusted at any time during treatment.

C. MODIFY TIME/PARAMETER button. Use to increase/decrease the treatment time or to change parameters in

SET mode.

D. LCD graphics screen for all functions and parameters. The graphics screen displays:



Modality selected



Program selected



Time remaining



Carrier Frequency



Bar graph for Vector and detection modes

LEAD WIRE TESTER connection and indicator LED. Plug the distal (patient end) of the lead wire into the test

connectors while observing polarity (red / black). Plug the device end of the lead wire into the receptacle

labeled LEAD WIRE TESTER. When the POWER is on, green LED will turn on if the lead wire passes the

test. LED will be red if the lead wires are faulty and need to be replaced.

OUTPUT CHANNEL A in SENSORY, MOTOR, and NERVE BLOCK PADS programs.

G. OUTPUT CHANNEL B in SENSORY, MOTOR, and NERVE BLOCK PADS programs.

H. PATIENT SAFETY switch. This is a remote duplicate of the START/STOP button. This is used by patients for

treatment interruption.

PATIENT GROUND connection. Patient ground pads for use in conjunction with the Point Stimulation Probe.