Accelerated Care Plus Neuroprobe 500 Pro User Manual page 27

26
Waveform:
Output:
II. SENSORY – MOTOR, IFC AND SLD INFRARED PAD PROTOCOLS
Electro therapy may be applied with medium frequency currents to provide greater tissue penetration and higher
comfort. Electro therapy with medium frequency current is applied using bipolar electrode placements whereas IFC
current is applied by crossing the electrodes over the desired treatment area. The current is passed through the
treatment site by creating a third vector field from the crossing or "interfering" of the two channels in the tissue.
The purpose of interferential current therapy is to provide deep tissue treatment, which is not generally obtainable
with conventional electrotherapy approaches. Its primary application is in the reduction of pain and in the
stimulation of increased blood flow in the deeper tissues and muscles.
The following pads programs are available in Sensory - Motor mode:
PADS SENSORY:
PARAMETER
Carrier frequency:
Burst frequency:
Burst rate scan:
Burst scan time:
Beat:
Sweep:
Rate Scan Time:
Modulation:
Vector:
Auto Intensity:
Treatment time:
Waveform:
Output:
PADS MOTOR:
PARAMETER
Carrier frequency:
Burst frequency:
Burst rate scan:
Burst scan time:
Beat:
Sweep:
Rate Scan Time:
Modulation:
Vector:
Auto Intensity:
COPYRIGHT © 2006 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
Burst Alternating Current
0 mA
DEFAULT VALUES
5.0 KHz
100Hz
20%
10 seconds
ON
OFF
15 minutes
Burst Alternating Current
0 mA
DEFAULT VALUES
2.5 KHz
8.5 Hz
50%
10 seconds
ON
OFF
0%
®
NEUROPROBE 500 PRO USER MANUAL
0 – 1.8 mA
RANGE OF USER
ADJUSTABLE VALUES
2.0 KHz, 2.5 KHz,
4.0 KHz, 5.0 KHz or
10 KHz
.0 Hz to 999 Hz
0 – 50%
0 – 20 Seconds
ON or OFF
OFF, Fast 90º, Slow 90º,
Fast 45º, Slow 45º
0 – 99 Minutes
0 – 99 mA
RANGE OF USER
ADJUSTABLE VALUES
.0 Hz to 999 Hz
0 – 50%
0 – 20 Seconds
ON or OFF
OFF, Fast 90º, Slow 90º,
Fast 45º, Slow 45º
0 – 20%