Neuroprobe ® 500 Pro Program Menu; Infrared; Sensory - Motor - Accelerated Care Plus Neuroprobe 500 Pro User Manual

®
NEUROPROBE 500 PRO USER MANUAL
SLD Infrared Pads are active when the treatment timer is on. Output is cycled at 45.4 KHz, 62.5 KHz and 83.3 KHz
with 1 min per frequency, and at a 50% duty factor.
PARAMETER
Polarity:
Treatment time:
The Sensory - Motor modality contains five pre-programmed IFC modes and two pre-programmed Probe modes. In
IFC mode, output is provided through the output A-B jacks. The phase of the channels is indicated by the color of
the tip pins. The black wires are of the same phase and the red wires in the opposite phase relative to each channel.
All variable parameters may be altered during operation.
I. SENSORY - MOTOR PROBE TREATMENT PROTOCOLS
The Sensory – Motor protocols contain two pre-programmed probe protocols. All parameters may be varied during
operation. The following probe programs are available:
PROBE SENSORY:
PARAMETER
Carrier frequency:
Burst frequency:
Burst rate scan:
Burst scan time:
Modulation:
Stim time:
Waveform:
Output:
PROBE MOTOR:
PARAMETER
Carrier frequency:
Burst frequency:
Burst rate scan:
Burst scan time:
Modulation:
Stim time:
COPYRIGHT © 2006 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
®
Neuroprobe 500 Pro Program Menu

Infrared

DEFAULT VALUES
+/-
15 minutes

Sensory - Motor

DEFAULT VALUES
5.0 KHz
100Hz
20%
10 Seconds
ON
60 Seconds
Burst Alternating Current
0 mA
DEFAULT VALUES
5.0 KHz
8.5Hz
50%
10 Seconds
ON
60 Seconds
RANGE OF USER
ADJUSTABLE VALUES
+/- or + or -
0 – 99 Minutes
RANGE OF USER
ADJUSTABLE VALUES
.0 Hz to 999 Hz
0 – 50%
0 – 20 Seconds
ON or OFF
0 – 999 Seconds
0 – 1.8 mA
RANGE OF USER
ADJUSTABLE VALUES
.0 Hz to 999 Hz
0 – 50%
0 – 20 Seconds
ON or OFF
0 – 999 Seconds
25