Controls And Functions - Accelerated Care Plus OMNISTIM FX2 PRO User Manual

10

Controls and Functions

A
B
C
D
A
E
A
A. Press button corresponding to the desired functional PROTOCOL group. Chose between PAIN, NEURO RE-
ED, MUSCLE RE-ED, FUNCTIONAL RE-ED, or FUNCTIONAL RE-ED ASSISTED.
B. MODIFY TIME/PARAMETER UP or DOWN buttons are used to increase/decrease treatment time or changes
parameters in SET mode.
C. SELECT PARAMETER button provides adjustment of stimulation parameters, audio on/off and button speed.
Press to enter SET mode. It is possible to adjust most stimulation parameters at any time during treatment.
D. Main power switch. Press for power ON, press again for power OFF. The display illuminates with default
display: SELECT PROTOCOL / TREATMENT OFF.
E. LEAD WIRE TESTER indicator LED. When lead wires are properly connected to the LEAD WIRE TESTER,
the LED will display green if lead wires function properly, and it will be red if lead wires are faulty or are not
connected to the LEAD WIRE TESTER properly.
F. Connector for the distal (patient end) of the lead wire when testing lead wire in the LEAD WIRE TESTER.
Observe proper polarity, and connect red lead wire into red connector.
G. Connector for the distal (patient end) of the lead wire when testing lead wire in the LEAD WIRE TESTER.
Observe proper polarity, and connect black lead wire into black connector.
H. Connector for the device end of the lead wire when testing lead wire in the LEAD WIRE TESTER.
I. AUX INPUT used to connect cable for remote hand control operation.
J. PATIENT SAFETY input switch connector.
COPYRIGHT © 2004 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
F
G H I
A
A A
®
OMNISTIM FX
L
J K
A
A
2
Pro USER MANUAL
V
A
U
A
T
A
S
A
R
A
Q
A P
A
O
A
N
M
M
A
A