Ifc Therapy With Pad Electrodes - Accelerated Care Plus Neuroprobe 500 Pro User Manual

Electrotherapy / infrared therapy system

Hide thumbs

Table Of Contents

Table of Contents

NEUROPROBE

500 PRO USER MANUAL



Press the MODIFY TIME / PARAMETER button to set the desired treatment time if you wish to change

from the default settings of 15 minutes. Press the up or down button to increase or decrease the duration

from a minimum of one minute to a maximum of 99 minutes. The timer will count down to zero during

treatment.

NOTE: The SLD Infrared Pads always operate for the indicated treatment time for the selected protocol

with the same output regardless of the electrotherapy protocol chosen. The SLD Infrared Pads pulse at

sequential frequencies of 45.4, 62.5, 83.3, KHz at a 50% duty factor. Each frequency is active for 1 minute.

The frequency sequence is repeated until the timer terminates the treatment. This sequencing is not

discernable to the user.



To stop the treatment, push the START/STOP button (3) once.



When the treatment time is down to zero, the treatment current is switched off and INFRARED THERAPY is

displayed.



Turn off the unit by pressing the POWER button (1/5).



Press the POWER button (1/5) to turn on the Neuroprobe

the unit will be in the SELECT MODALITY/PROGRAM mode.



Select the treatment modality desired and the appropriate treatment program by using the modality buttons

(2) to select Sensory Motor, or Nerve Block pad programs.



Press the SELECT PARAMETERS button to select any settings to be modified.

TIME/PARAMETER button to adjust the desired treatment time, or other settings, if you wish to change from

the default settings. Time is preset to 15 or 30 minutes (dependent on the protocol selected). Press the up or

down buttons to increase or decrease the duration from a minimum of one minute to a maximum of 99 minutes.



Position the electrodes on the patient, connect the electrode lead wires and press the START/STOP button

(3). The treatment timer will begin, and the screen will provide basic treatment parameters, and will read

as follows (i.e. if Pads Nerve Block was selected):