Power Supply Operation; Operational Sequence; Infrared Therapy With Sld Pads - Accelerated Care Plus Neuroprobe 500 Pro User Manual

Electrotherapy / infrared therapy system

Hide thumbs

Table Of Contents

Table of Contents

LASER ON or OFF activates the additional LASER parameter selections and dosage options. This mode should

be used only with the Neuroprobe

operator manual supplement.

NOTE: The factory settings cannot be accessed during operation and are only available following the start up

screen.

Neuroprobe

500 Pro is a line power only device. It is not intended for use with batteries.

When the Power Supply is plugged into the unit, the LED on top right of the Neuroprobe

stays on as long as the Power Supply is plugged into the unit and connected to the AC power.



Select the dual rectangular, knee, elbow, neck, back or lower extremity SLD Infrared Pad. Plug it into the

probe output socket.



Apply the SLD Infrared Pad to the treatment area. Use an infection control cover over the SLD Infrared

Pad and proper infection control procedures. Use the Velcro

straps to gently place the SLD Infrared Pad (s) over the treatment area. Position the pad (s) so that the RED

SLD are placed over the key nerves, arteries and acu/trigger points for treatment of the knee, back or lower

extremity based on the pad used.



Press the POWER button (1/5) to turn on the Neuroprobe

the unit will be in the SELECT MODALITY/PROGRAM mode.



Select the Infrared Therapy treatment program by using the MODALITY button (2). Note that although the

SLD PADS will function in probe modes, the detection and electro-stimulation feature of the probe will not

be available as the SLD INFRARED PADS plug into the same output socket as the probe.



To start the treatment, push the START/STOP button (3) once. The following screen will be displayed.

500 Pro optional LASER probes and is covered in the LASER probe