Omron R88D-1SN10F-ECT User Manual page 811

Event name Lifetime Information Corruption Warning
Description An error was detected in the saved lifetime information.
EtherCAT Master Function Mod-
Source
ule
Error
Level
attributes
Effects User program Continues.
EtherCAT NET RUN
Indicators
---
System Variable
-defined
None
variables
Assumed cause
The lifetime information corrup-
tion was detected when the
power supply was turned ON
Cause and
correction
Attached None
information
Precautions/ AL status code: -, Error No.: A705 hex
Remarks
*1. You can change the level to minor fault by using Warning Level Change 1 Selection (4020-05 hex).
Event name Data Setting Warning
Description The object set value is out of the range.
EtherCAT Master Function Mod-
Source
ule
Error
Level
attributes
Effects User program Continues.
EtherCAT NET RUN
Indicators
---
System Variable
-defined
None
variables
Assumed cause
Cause and
The object set value is out of the
correction
range
Attached None
information
Precautions/ AL status code: -, Error No.: B000 hex
Remarks
*1. You can change the level to minor fault by using Warning Level Change 1 Selection (4020-05 hex).
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User's Manual (I586)
Source details
*1
Observation
Recovery
Operation
EtherCAT NET ERR
---
Data type
None
Correction
Perform the Lifetime Information
Clear. Note that the lifetime may
not be detected correctly after the
clear operation because the value
of lifetime information is cleared. If
this event occurs repeatedly, the
area to save lifetime information is
faulty. Replace the Servo Drive.
Source details
*1
Observation
Recovery
Operation
EtherCAT NET ERR
---
Data type
None
Correction
Correct the object setting to be
within the specified range.
Event code 1839 0000 hex
Slave Detection
timing
---
Log category
Not affected.
EtherCAT LINK/ACT
---
Name
None
Prevention
None
Event code 34E00000 hex
Slave Detection
timing
---
Log category
Not affected.
EtherCAT LINK/ACT
---
Name
None
Prevention
Correct the object setting to be
within the specified range.
Appendices
At power ON
System log
A
Continuously
System log
A - 163