SOLE 16608700200 Owner's Manual page 14

4
PLASTIC COVERS
61
Note: Use the M5 Allen Wrench/Phillips Head Screw Driver (108) to tighten hardware in this step.
1. Locate the Console Assembly (31) and the four Phillips Head Screws (78).
There will be two electrical wire connectors at the top opening of the
Console Mast (10), two Hand pulse wires (37), one Computer Cable (32).
Connect these to the mating connectors on the back of the Console Assembly
(31). The connectors are keyed so you cannot plug them in the wrong way so
do not force them.
2. Storing the excess wire back into the Console Mast (10), carefully install the
Console Assembly (31) onto the mounting plate of Console Mast (10) and
secure using the four Phillips Head Screws (78)
3. Install the two pcs of Slide Wheel Covers (52) and the four Phillips Head
Screws (79) by using the Phillips Head Screwdriver (110).
4. Use one Phillips Head Screw (79) to secure Rear Stabilizer Cover (L) (61) on
the Pedal Arm (L) and Rail Tube with Phillips Head Screwdriver (110). Repeat
the procedure for Rear Stabilizer Cover (R) (62) for the other side.
5. Use two Phillips Head Screw (79) to secure Middle Stabilizer Cover (59) on the
Pedal Arm (L.R) and Rail Tube with Phillips Head Screwdriver (110).
6. Use Phillips head screw driver to tighten Drink Bottle Holder (68‐2) on Console
Mast tube with two M5 × 12m/m Phillips Head Screws (68‐3).
customerservice@dyaco.ca
79
79 59
52
79
79
62
31
32
37
78
68-2
68-3
79
79 59
52
14
HARDWARE STEP 4
#78. M5 x 10mm
Phillips Head Screw
(4 pcs)
#79. M5 x 15mm
Phillips Head Screw
(8 pcs)
#68‐3.M5 x 12mm
Philips Head Screw (2 pcs)
Dyaco Canada Inc. 2017