Output And Routing Switcher Setup - Orban OPTIMOD-PC 1101 Operating Manual

OPTIMOD-PC
To do this, check (by clicking) the B
both) of the A
of the D
IGITAL
D 2 I
IGITAL NPUT
You can set these functions separately on the Processor mixer and the Di-
rect Mixers. The three mixers will behave independently according to
their individually set programming.
If both "backup for digital 1" and "mute" are selected, the backup func-
tion will override the mute function.

Output and Routing Switcher Setup

The output routing switcher, found in the O
the feed to:
•
The OPTIMOD-PC card's stereo analog output
•
The OPTIMOD-PC card's two AES3 digital outputs
•
The two WAVE inputs to the computer.
Each output is independently routed and can receive any of the following sources:
•
The direct WAVE 1 and 2 outputs from the computer
•
The output of Direct Mixer 1 or Direct Mixer 2
•
The Processor Mixer AGC output taken before the equalizers (i.e. the equali-
zation sections whose controls are available in the EQ tab of the Control
Application)
L/R and D
NALOG IGITAL
1 I will automatically unmute only the D
NPUT
then fails, the A
NALOG
I F D
ACKUP NPUT OR IGITAL
2 inputs. If both are checked, then a failure
will automatically unmute.
L/R I
NPUT
page of the I/O Mixer, sets
L
UTPUT EVELS
INSTALLATION
1 box on either (or
2 I . If the
IGITAL NPUT
2-39