Creating Custom "Factory" Presets - Orban OPTIMOD-PC 1101 Operating Manual

OPTIMOD-PC

Creating Custom "Factory" Presets

You can create custom "factory" presets that support L
These presets will behave like Orban's factory presets.
Your 1101's software has the ability to interpolate all 19 available L
ments (1.0 through 10.0) from two or more L
tion, there must be a "factory preset" file. The instructions below show you how to
create these files from user preset files that you have saved.
In the examples below, the specified file locations are based on OPTIMOD-PC's de-
fault locations. Using Windows Explorer, check the factory preset file locations on
your computer to find out where these files are actually located. You must place
your new "factory preset" files in analogous locations.
To create a custom "factory" preset:
1. Choose a name for the preset.
You cannot use the name of an existing factory preset without damaging it. We
will use "My Preset" as the preset name in the examples below.
2. Create a folder for your presets.
Create a folder named "My Preset" within the directory
\Program Files\Orban\OPTIMOD-PC2\presets
You should see all of the subdirectories for Orban's factory presets in this
director
3. Choose the default L
4. Using the OPTIMOD-PC Control Application, create user presets for each
L -M anchor point.
ESS ORE
See User Processing Presets starting on page 1-17.
Because L
-M
ESS
set of equalizer settings for your new preset that is the same for all anchor pre-
sets. Table 3-4: Equalizer Controls on page 3-37 shows the controls that must be
set identically in all anchor presets.
You must create at least two anchor presets, one for L
for L -M
ESS ORE
step 3 is neither 1.0 nor 10.0, you must create a third anchor preset for the de-
fault L -M
ESS ORE
You may add as many additional anchor presets as you wish to fine-tune the be-
havior of L
ESS
sets.
From the OPTIMOD-PC Control Application, save each preset as a user preset in
plain text (unencrypted) form, naming it
value for your preset.
-M
ESS ORE
works only on the dynamics processing, you must choose a
ORE
= 10.0. Additionally, if the default L
value.
. Some Orban factory presets use as many as six anchor pre-
-M
ORE
-M
ESS
"anchor" preset files. In addi-
-M
ESS ORE
-M
ESS ORE
value you chose in
-M
ESS ORE
My Preset LMxxx , where
OPERATION
functionality.
ORE
-More incre-
ESS
= 1.0 and one
xxx stands for
3-69