Serial Port 'A' Configuration Jumper - Intel R1000WF System Integration And Service Manual

Intel ® Server System R1000WF Product Family System Integration and Service Guide
Note: System Update Packages (SUP) can be downloaded from Intel's download center web site.
http://downloadcenter.intel.com
1. Turn off the system
2. For safety, remove the AC power cords
3. Remove the system top cover
4. Move the "BIOS Recovery" jumper from pins 1 - 2 (default) to pins 2 - 3 (BIOS Recovery position)
5. Re-install the system top cover and re-attach the AC power cords
6. Power on the system
7. The system will automatically boot to the EFI shell. Update the BIOS using the standard BIOS update
instructions provided with the system update package
8. After the BIOS update has successfully completed, power off the system. For safety, remove the AC
power cords from the system
9. Remove the system top cover
10. Move the BIOS Recovery jumper back to pins 1-2 (default)
11. Re-install the system top cover and re-attach the AC power cords
12. Power on the system and access the <F2> BIOS Setup utility
13. Configure desired BIOS settings
14. Hit the <F10> key to save and exit the utility
6.2.6

Serial Port 'A' Configuration Jumper

Pin 7 of the RJ45 Serial A connector is configurable to support either a DSR (Default) signal or a DCD signal.
Pin 7 signals are changed by moving the jumper on the jumper block labeled "J4A2", located next to the
connector, from pins 1-2 (default) to pins 2-3.
78