Initial Setting And Adjustment Of The Joystick Control System Operation - ILMOR ONE-TOUCH Owner's Manual

SECTION 3 ILMOR ONE-TOUCH OWNER'S MANUAL
3-6
INITIAL SETTING AND ADJUSTMENT OF
THE JOYSTICK CONTROL SYSTEM
OPERATION
In the Joystick Control System operation, you do not need to perform the
initial setting (calibration) or adjustment. However, if you wish to make
adjustment, consult your authorized Ilmor dealer or distributor. Also,
you can make slight adjustment (calibration) by yourself in the following
procedure:
Calibration
Calibrate the boat in a place where there is little wind and no tidal current.
Check Before Calibration
• Move the control head shift lever to the neutral position.
• Press the A button on the joystick to switch to the joystick.
• Move the joystick lever to the center position.
Calibrating
Calibrate the boat in the sideways direction and diagonal direction. First,
calibrate the boat in the sideways direction and then, in the diagonal
direction.
Calibrating in the Sideways Direction
• Press and hold the A button for 5 seconds to start calibrating in the
sideways direction, a beep sounds continuously, the A button flashes
and you can calibrate in the sideways direction. A beep sounds stops
when the calibration is done.
The calibration condition is shown on the display. If you move the
joystick within the settings range, the Green Zone is shown and you can
calibrate. If you move the joystick outside the range, the Red Zone is
shown. In this case, you cannot calibrate.
To show the Green Zone, move the joystick in the sideways direction.
Joystick horizontal adj
Operate the lever in horizontal direction,
then push "SET" button on the joystick
for calibration.
SET VALUE
ENGINE SPEED
r/min
Figure 3-5
© 6/2016 Ilmor Marine Engines, Version 1.0
r/min
048263-00X00