Operating For Autopilot - ILMOR ONE-TOUCH Owner's Manual

OPERATING FOR AUTOPILOT

Check on the Ilmor Vessel Control System Display
Before Operation
When operating the autopilot system, confirm that the autopilot icon
appears on the Ilmor Vessel Control System display. Then, operate the
autopilot from the autopilot system side.
STAND-BY on the Ilmor Vessel Control System
Display
The usual stand-by operation is performed by the autopilot system side,
not performed by the Ilmor Vessel Control System side. When the stand-by
operation cannot be performed on the autopilot display, it can be operated
from the Ilmor Vessel Control System display.
The operating procedure is as follows.
1. Press [ENTER] button on the display, and [MAIN MENU] is indicated.
2. Select [Autopilot] from [MAIN MENU] and set [Request Stand-by].
Autopilot
Alarms/DIAGs
Display
Engine speed
Monitor settings
Synchro
Trolling
EPS
Joystick
Utility
© 6/2016 Ilmor Marine Engines, Version 1.0
APPENDIX: AUTOPILOT SYSTEM
40 40
20 20
0 0
AP
Figure 6-1
MAIN MENU
Request Stand-by
Figure 6-2
40 40
20 20
055675-00X00
055668-00EN00
6-2