ILMOR ONE-TOUCH Owner's Manual page 16

SECTION 3 ILMOR ONE-TOUCH OWNER'S MANUAL
3-8
NOTE: If you calibrate in one sideways direction (left or right), you don't
need to calibrate in the opposite sideways direction.
Calibrating in the Diagonal Direction
• Press and hold the B button for 5 seconds, a beep sounds continuously
and the B button flashes and you can calibrate in the diagonal direction.
A beep sounds stops when the calibration is done. The calibration
condition is shown on the display. If you move the joystick within the
settings range, the Green Zone is shown and you can calibrate. If you
move the joystick outside the range, the Red Zone is shown. In this case,
you cannot calibrate. To show the Green Zone, move the joystick 30
degrees in the diagonal direction.
Operate the lever in forward diagonal
direction then push "SET" button on
the joystick for calibration.
• Move the joystick lever 30 degrees diagonally forward (left or right). The
B button changes from flashing to lighting and the system is ready to
calibrate.
• If the boat slews while moving, twist the top of the joystick to the
opposite direction of slewing as shown in below illustration and while
maintaining the non-slewing condition, press the B button to calibrate.
2
1
3
2
4
Figure 3-9
Joystick diagonal adj
SET VALUE
ENGINE SPEED
r/min
Figure 3-10
© 6/2016 Ilmor Marine Engines, Version 1.0
041929-01X00
r/min
050385-00EN00