Metra Electronics 99-3400 Installation Instructions Manual page 10

DIN head unit provision
1. Cut and remove the shaft supports from
the spacer and radio housing.
2. Slide the DIN cage into the kit and
secure by bending the metal locking
tabs down. (Figure A)
3. Slide the aftermarket head unit into the
cage until secure. (Figure A)
(If an equalizer will be included, slide
the unit into the back of the radio
housing and secure. If an equalizer will
not be included, snap the equalizer
dummy plate into the opening).
4. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
5. Reassemble dash in reverse order
of disassembly. (Figure B)
Kit Assembly 99-3400
Optional
(Figure A)
(Figure B)