Downloading Of Target Systems; Downloading Of Target Systems (Page 73) - Siemens SIMATIC PCS 7 Service Manual

Downloading of Target Systems

8.1 Downloading of Target Systems
Once you have updated your PCS 7 project offline, you must download the changes to the
target systems.
NOTICE
Updating a redundant OS in runtime
Updating a redundant OS during operation (according to the manual Process Control System
PCS 7, Fault-tolerant Process Control Systems; Guidelines for updating a redundant OS in
runtime)
If you update a redundant OS during operation, do not load the AS until phase 3 (in step 6 of
the Fault-tolerant Process Control Systems manual).
Requirement
● The network addresses and network settings of the PC stations are configured.
● The configuration of the PC stations match in HW Config and in the Station Configuration
Editor.
● The PC station has been configured.
● The configuration and connection data of all stations has been downloaded via NetPro.
Procedure
1. Use the search box in the start menu to open "Set PG-PC Station".
2. Check the setting of the access points on each PC station (locally).
3. You can successively download all target systems systematically and automatically.
In the SIMATIC Manager, select the menu command Target system > Compile and
Download Objects.
Additional information
You can find additional information about this in the
Engineering System manual.
Software update without utilization of new functions
Service Manual, 03/2016, A5E36200133-AA
Process Control System PCS 7;
8
73