ITech IT6722 User Manual page 35

4. VFD display >TIME SEC，press
you can also through
Enter
to confirm.
5. VFD display >VSET 0.0, press number key
knob to set voltage，after that press
6. VFD display ISET 0.00, press number key
set the single-step current, press
7. VFD display SEC 0.100, press number key
set single-step delay time，press
If you choose MIN for the 4
time range 0.1~9999min.
8. VFD display NEXT >YES，press
9. Repeat the steps from 5) to 8) and set the four steps' voltage/current and
delay time separately. When screen display NEXT>YES in the fourth step
edit process, please press
confirm.
10. VFD display REPET 1，press number key
set the repeat times，press
11. VFD display SAVE >NO，press
the list file is not saved but can run for one time,or you can press
to select >SAVE FILE0,saving the list test file in FILE0~FILE9，press
Enter
to confirm.You can recall the file in the following utilization.
12. If you do not save the list test file, VFD will display LIST EDIT;if you select
to save the test file,VFD will display SAVE DONE for three seconds,and
then display LIST EDITL.
Set List State
13. Press to select >LIST STATE item，press
14. VFD display LIST >OFF, press
Enter
confirm.Now
function has been opened.
15. VFD display >LIST STATE，pressing
Run list file
On/Off
16. Press button to open the output，press
（Trigger）to give a trigger signal.
Recall list file
17. If you have edited several list files,you can select LIST LOAD item to recall
the file you need.And then press
button to open the output.Now you only need to press
(Trigger) to give a trigger signal,the list file can be ran.
Quit list file
Copyright © Itech Electronics Co., Ltd.
Enter
to confirm，go to the next step,
button to select >TIME MIN time unit，press
Enter
0
Enter
to confirm.
Enter
to confirm(range is 0.1-9999).
th
step, VFD will display MIN 0.100 for this step,
Enter
to confirm.
to select NEXT >NO,press
0
Enter
to confirm.
Enter
to confirm，in this circumstance,
to select >LIST >ON, press
button will be lit.This indicates that list operation
Esc
button can quit the operation.
Esc
to quit this operation.Press
Function
and Features
0 9
to or through rotary
to confirm.
9
to or rotary knob to
0 9
to or rotary knob to
Enter
9
to or rotary knob to
Enter
to confirm.
Enter
Enter
(Shift)+
(Shift)+
to
button
to
On/Off
Enter
28