Permanent Caller Id Block Release; Phone Configurator - Polycom 400 User Manual

2. Press the one-touch transfer button (J Smith VM) to transfer
the call.
3. Hang up.

Permanent Caller ID Block Release

If you chose to always have your caller ID information blocked on all
calls, this feature allows your caller ID information to be sent for this
call only.
Your caller ID may be required for some calls to be completed. If
your call will not be accepted without caller ID information you may
get a message that the number you called will not accept
anonymous (no caller ID) calls. You may use this feature to send
caller ID information for that call only.
To allow your caller ID to be displayed on the phone you are calling:
1. Press *82.
2. Dial the desired phone number.
The called number should either ring or be busy. You should
not get the anonymous call rejection message.

Phone Configurator

The PressOne system allows the system administrator to configure
your phone in the database before it is physically installed. You can
then pick up the handset and enter your phone number and
password (provided by your system administrator), and it will be
assigned to your phone.
It also allows you to find out the telephone number and IP address
assigned to any telephone. Using the Configurator, you can also re-
assign your phone number to another telephone of a similar type
(usually for a temporary period at another location) and then re-
assign the number to back your regular telephone set.
Polycom Telephone User Guide
621-00000092
VocalData Telephone Features 49