Change Password - Polycom SpectraLink 1725-36032-001 Administration Manual

Change Password

PN: 1725-36032-001_G.doc
traffic is the audio traffic to the PBX. It requires voice quality.
RTP
traffic is not audio to the PBX.
PBX
traffic is the information-passing protocol that SVP
Inter-SVP2
Servers use to communicate with each other.
The final DSCP tag of traffic for packets in each of the above Traffic
Classes is governed by the logic below when SVP is used in an SRP
environment:
• If in-call and
WT (In call)
value is used. Valid range is 0-63.
• If not in-call and
WT (Standby)
configured value is used. Valid range is 0-63.
• means "shall not change value of DSCP tag", in other
Default
words the received DSCP value (from the Gateway) is passed
transparently.
Reset System
If this option is selected, you will be prompted to reset the SVP Server
upon exiting this screen.
The SVP Server should be reset at the end of any maintenance
procedure that requires a reset either via
Reset System.
manually via
Note that resetting the SVP Server will terminate any calls in
progress.
If desired, the password to access the SVP Server may be changed.
A password must meet the following requirements:
• It must be more than four characters, but cannot exceed 16
characters.
• The first character must be a letter.
• Numbers or letters are allowed.
• No dashes, spaces, or punctuation marks, etc. are allowed.
Configuring the SpectraLink 8000 SVP Server
value is not then the configured
Default
value is not
Default
Maintenance Lock
then the
or
27