Single Msr Module Installation - Advantech EP-55XX-AR10 User Manual

Single MSR Module Installation

1. Turn off the system power properly through the operating system, then turn off any external
devices.
2. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
3. Remove the two screws from the left MSR side cover on the back of the display.
4. Secrew a screw as shown below.
5. Connect the single MSR module's signal cable connector into the socket. Next, fix MSR module with
two screws.
Regardless of the power-on state, voltage is always present on the main board as
long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the system.
25