Table of Contents
Advertisement
Chapter 3
MSR/Fingerprint/I-Button/IC Card Module Installation
NOTE:
1. Turn off the system power properly through the operating system, then turn off any external
devices.
2. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
3. Detach the right side cover.
4. Connect MSR cable into the socket.
5. Slide the MSR into the main LCD display. Reattach the two screws that secure the MSR to the main
system.
Optional Components and Peripherals
The MSR module can only be installed to its designated position and socket; the
same with the wireless module. Their locations are not interchangeable.
Regardless of the power-on state, voltage is always present on the main board as
long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the system.
18
Advertisement
Table of Contents
