Head Light Adjustment; Front Direction Indicators - VESPA LXV 125 ie 2013 Manual

Head light adjustment (03_32, 03_33)

Proceed as follows:
1. Place the vehicle, in running order and with the tyres inflated to the prescribed
pressure, on a flat surface 10-m away from a white screen situated in a shaded area,
making sure that the longitudinal axis of the scooter is perpendicular to the screen;
2. Turn on the headlight and check that the borderline of the projected light beam on
the screen is no higher than 9/10 or lower than 7/10 of the distance from the ground
to the centre of the vehicle's headlamp;
03_32
3. Otherwise loosen the rear screw on just one side, press or pull the top of the head-
light slightly to adjust its position.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE VE-
HICLE IS USED.
03_33

Front direction indicators (03_34, 03_35)

To replace the bulbs:
1. Remove the turn indicator from its fitting by undoing the screw «A».
2. Take out the bulb holder «B» from its fitting by turning it anticlockwise.
3. Press the bulb, turn it anticlockwise and then take it out.
To refit, proceed in reverse order.
03_34
60