Vega VEGABAR 52 Operating Instructions Manual page 33

VEGABAR 52 • 4 ... 20 mA/HART
6 Set up with the indicating and adjustment module PLICSCOM
To select the adjustment unit (in the example switching over from bar
to mbar), proceed as follows:
Push the [OK] button in the measured value display, the menu
1
overview is displayed.
Basic adjustment
▶
Display
Diagnostics
Service
Info
Confirm the menu "Basic adjustment" with [OK], the menu item
2
"Unit" will be displayed.
Unit
Unit of measurement
▼
bar
Temperature unit
°C
▼
Activate the selection with [OK] and select "Units of measure-
3
ment with [->].
Activate the selection with [OK] and select the requested unit with
4
[->] (in the example mbar).
Confirm with [OK] and move to position correction with [->].
5
The adjustment unit is thus switched over from bar to mbar.
Information:
When switching over to adjustment in a height unit (in the example
from bar to m), the density also has to be entered.
Proceed as follows:
Push the [OK] button in the measured value display, the menu
1
overview is displayed.
Confirm the menu "Basic adjustment" with [OK], the menu item
2
"Units of measurement" will be displayed.
Activate the selection with [OK] and select the requested unit with
3
[->] (in the example m).
Confirm with [OK], the submenu "Density unit" appears.
4
Unit of measurement
Density unit
kg/dm³
▶
pcf
Select the requested unit, e.g. kg/dm³ with [->] and confirm with
5
[OK], the submenu "Density" appears.
Selection options: mbar, bar, psi, Pa, kPa, MPa, inHg, mmHg, inH
2)
mmH
O.
2
2)
O,
2
33